SkyLink R4G Universal Remote User Manual


  Open as PDF
of 4
 
–
3
–
Relay Trigger Pulse Duration
To change the setting:
Display Display
-> -> -> then enter;
Press Press
[1] for 0.3 second
[2] for 0.5 second
[3] for 1.0 second
[4] for 2.0 seconds
[5] for 5.0 seconds
If hear 3 beeps, confirmed the change in relay trigger duration setting.
Note : The factory default is 0.3 second.
Enable / Disable Beeping
To change the beep setting:
Display Display
-> -> -> then enter;
Press Press
[1] enable beeping
[2] disable beeping
If hear 3 beeps, confirmed the change in beep setting.
Note : The factory default is Enable.
ADV
SET
2
ADV
SET
3
Advanced Features
Relay Trigger Selection: NO/NC/Toggle
Display Display
-> -> -> then enter;
Press Press
[1] for NO – the RELAY LED will stay off.
[2] for NC – the RELAY LED will stay on.
[3] for Toggle – the RELAY LED will subject to previous relay setting. If the relay is in NO, then the RELAY LED will keep stay off. After activated, the
RELAY LED will change to on. If the relay is in NC, then the RELAY LED will keep stay on. After activated, the RELAY LED will change to off.
If hear 3 beeps, confirmed the change in relay trigger setting.
Note: The factory default is set to NO.
ADV
SET
1
3. OPERATION (CONT)
Erase/Format memory
The memory can be completely erased or formatted.
To erase/format memory:
Display Display Display
-> -> -> then enter or -> ->
Press Press Press
[1] to erase the1st memory
[2] to erase the 2nd memory
If hear 3 beeps, confirmed the memory content is copied. You need to restart the unit by disconnecting the power supply then reconnects it again.
ADV
SET
0
1
2
 previous