Filter
Top Products
9
GB
Getting Started
About the installation position
Install the stand after connecting all the
components to the stand.
Install the stand after allowing for a space of
more than 5 cm from the wall. This is to allow
for heat dissipation and to prevent the TV from
falling.
The stand has a back corner cut to fit in the
corner of a room. If you install the stand in a
corner of your room, it requires a space of about
86 cm from the corner of the room to the front of
the stand.
• Be careful not to pinch your fingers when setting up
the stand.
Preventing the TV from
toppling over
As a protective measure, secure the TV.
Perform following steps as a protective measure
if you have a Sony LCD TV.
1 Place the TV on the stand.
The TV should be placed in the centre of the
stand, aligning the rear edge of the TV’s
base with the stand’s rear edge.
2 Fix the support belt to the TV firmly.
The support belt is attached on the rear of
the stand. Place the tip of the support belt on
the TV, then insert and tighten the screw for
the support belt (supplied), using a coin, etc.
3 Pull the support belt against the TV to
secure the TV firmly to the stand.
Setting this stand
Note
More than
5cm
86 cm
Support belt
continued