Filter
Top Products
38
BDP-S5500/BDP-S4500/BDP-S1500
4-549-800-11(2)
master page=left
E:\SONY
DVD\SD140038\4549800112_GB\070ADD.fm
, When you connect the player to a TV
through an AV amplifier (receiver),
– if the AV amplifier (receiver) is not
compatible with the [Control for
HDMI] function, you may be unable
to control the TV from the player.
– if you change the HDMI
connection, disconnect and
reconnect the mains lead, or a power
failure occurs, try the following:
1Switch the input selector of the
AV amplifier (receiver) so that the
picture from the player appears on
the TV screen.
2Set [Control for
HDMI] in [HDMI Settings] to [Off],
then set [Control for HDMI] in
[HDMI Settings] to [On] (page 32).
Refer to the instruction manual
supplied with the AV amplifier
(receiver).
The System Power-Off function does
not work (BRAVIA Sync).
, Check that [Control for HDMI] and
[Linked to TV-off] in [HDMI Settings]
are set to [On] and [Valid] (page 32).
Playback does not start from the
beginning of content.
, Press OPTIONS, and select [Play from
start].
Playback does not start from the
resume point where you last stopped
playing.
, The resume point may be cleared from
memory depending on the disc when
– you open the disc tray.
– you disconnect the USB device.
– you play other content.
– you turn off the player.
Message Code 1 [Playback stopped.
The content being played is protected
by Cinavia and is not authorized for
playback on this device. For more
information, see http://
www.cinavia.com. Message Code 1.]
appears on the screen when playing a
disc.
, The audio track of the video that you
are playing contains a Cinavia code
indicating it was intended for
presentation using professional
equipment only and is not authorised
for playback by consumers (page 6).
The disc tray does not open and you
cannot remove the disc even after you
press Z.
, Try the following: 1Turn the player
off, and disconnect the mains lead.
2Reconnect the mains lead while
pressing down Z on the player.
3Keep pressing down Z on the player
until the tray opens.
4Remove the
disc.
5Disconnect and reconnect the
mains lead again to recover the player.
The message [[EJECT] Key is
currently unavailable.] appears on
the screen after Z (open/close) is
pressed.
, Contact your nearest Sony dealer or
local authorised Sony service facility.
The player does not respond to any
button.
, Moisture has condensed inside the
player (page 4).
Others