Filter
Top Products
6
GB
F:\Sony SEM HA\Data_36DW\JC06xxx_26823941136DW_GB\2682394111\GB03CON_HTP-
36DW_CEL.fm
masterpage: Left
HTP-36DW
2-682-394-11 (1)
About the indicators on the display
MEMORY
L C R
SL
S
SR
SW
LFE
SP
RDS
STEREO MONOD.RANGE
SLEEP OPT COAX
DIGITAL
;
DTS
;
PRO LOGIC II
q; 9qd
qf
qaqs
214356 7
8
Name Function
A SW Lights up when audio signal is
output from the SUB WOOFER
jack.
B LFE Lights up when the disc being
played back contains an LFE
(Low Frequency Effect)
channel and the LFE channel
signal is actually being
reproduced.
C SP Lights up when the receiver is
turned on. This indicator does
not light up if a headphone is
connected to the PHONES jack.
D ;DIGITAL Lights up when Dolby Digital
signals are input.
Note
When playing a Dolby Digital
format disc, be sure that you
have made digital connections
and that INPUT MODE is not
set to “ANALOG” (page 52).
E ; PRO
LOGIC (II)
“; PRO LOGIC” lights up
when the receiver applies Pro
Logic processing to 2 channel
signals in order to output the
center and surround channel
signals. “; PRO LOGIC II”
lights up when the Pro Logic II
Movie/Music decoder is
activated.
Note
Dolby Pro Logic and Dolby Pro
Logic II decoding do not
function for DTS format
signals.
Name Function
F DTS Lights up when DTS signals are
input.
Note
When playing a DTS format
disc, be sure that you have made
digital connections and that
INPUT MODE is not set to
“ANALOG” (page 52).
G MEMORY Lights up when a memory
function, such as Name Input,
Preset Memory (page 49), etc.,
is activated.
H Preset
station
indicators
Lights up when using the
receiver to tune in radio stations
you have preset. For details on
presetting radio stations, see
page 48.
I Tuner
indicators
Lights up when using the
receiver to tune in radio stations
(page 46), etc.
J D.RANGE Lights up when dynamic range
compression is activated (page
34).
K COAX Lights up when INPUT MODE
is set to “AUTO” and the source
signal is a digital signal being
input through the COAXIAL
jack, or when INPUT MODE is
set to “COAX IN” (page 52).
L OPT Lights up when INPUT MODE
is set to “AUTO” and the source
signal is a digital signal being
input through the OPTICAL
jack, or when INPUT MODE is
set to “OPT IN” (page 52).
GB01COV_HTP-36DW_CEL.book Page 6 Wednesday, February 22, 2006 1:48 PM