Filter
Top Products
47
EN
Additional Information
Additional Information
Specifications
CD/DVD player
Laser Semiconductor laser
Signal format system NTSC (for DVD and VIDEO CD)
PAL (for VIDEO CD)
Audio characteristics
Frequency response DVD (PCM): 2 Hz to 22 kHz (±0.5 dB)
CD: 2 Hz to 20 kHz (±0.5 dB)
Signal-to-noise ratio More than 107 dB
Harmonic distortion Less than 0.0028%
Dynamic range More than 97 dB
Wow and flutter Less than detected value
(±0.001% W PEAK)
Outputs and inputs
LINE OUT
(AUDIO 1, 2)
DIGITAL OUT
(OPTICAL)
DIGITAL OUT
(COAXIAL)
LINE OUT
(VIDEO)
S VIDEO OUT
COMPONENT
VIDEO OUT
(Y, B-Y, R-Y)
PHONES
CONTROL S
General
Power requirements 220 to 240 V AC, 50 Hz
Power consumption 28 W
Dimensions (approx.) 430 × 111 × 395 mm (w/h/d)
incl. projecting parts
Mass (approx.) 7.0 kg
Operating temperature 5 ˚C to 35 ˚C
Operating humidity 5% to 90%
Supplied accessories
See page 6.
Design and specifications are subject to change without notice.
Jack
type
Phono
jacks
Optical
output
connector
Phono
jacks
Phono
jack
4-pin mini
DIN
Phono
jacks
Phone
jack
Mini jack
Maximum
output
level
2 Vrms
(at 50 kilohms)
–18 dBm
0.5 Vp-p
1.0 Vp-p
Y: 1.0 Vp-p
C: 0.286 Vp-p
Y: 1.0 Vp-p
B-Y, R-Y:
0.7 Vp-p
12 mW
Load impedance
Over 10 kilohms
Wave length: 660 nm
75 ohms terminated
75 ohms,
sync negative
75 ohms,
sync negative
75 ohms terminated
75 ohms,
sync negative
75 ohms
Over 8 ohms
Messages do not appear on the TV screen in the language
you want.
/ In the menu, select the language for the on-
screen display in “OSD LANGUAGE” in
“INITIAL SETUP.” (page 44)
The language for the sound cannot be changed when you
play a DVD.
/ Multilingual sound is not recorded on the DVD.
/ Changing the language for the sound is
prohibited on the DVD.
The language for the sub-titles cannot be changed when
you play a DVD.
/ Multilingual sub-titles are not recorded on the
DVD.
/ Changing the language for the sub-titles is
prohibited on the DVD.
The sub-titles cannot be turned off when you play a DVD.
/ Depending on the DVD, you may not be able to
turn the sub-titles off.
The angles cannot be changed when you play a DVD.
/ Multi-angles are not recorded on the DVD.
/ Change the angles when “ANGLE” appears on
the front panel display. (page 39)
/ Changing the angles is prohibited on the DVD.
The aspect ratio of the screen cannot be changed though
you set “VIDEO ASPECT RATIO” in “INITIAL SETUP” in the
menu when you play a wide picture.
/ The aspect ratio is fixed on your DVD.
The menu screen does not appear when you play a VIDEO
CD.
/ The VIDEO CD does not feature PBC functions.
/ Follow the correct operating procedure. (Also
refer to the instructions supplied with the disc.)
The sound loses stereo effect when you play a VIDEO CD
or a CD.
/ “1/L” or “2/R” appears on the front panel
display.
On the remote, press AUDIO CHANGE
repeatedly until “1/L 2/R ” appears. (page 37)
In the menu, set “L/R/STEREO” in “CUSTOM
SETUP” to “STEREO.” (page 42)
The player does not operate properly.
/ Static electricity, etc. may affect the player's
operation.
Disconnect the AC power cord once, then
connect it again.
The picture jitters in Slow-motion Play mode.
/ In the menu, set “PAUSE MODE” in “CUSTOM
SETUP” to “AUTO.” (page 43)