Sony DVP-M50 DVD Player User Manual


 
23
OPERATION
Additional Information
Last Condition Memory
This player memorizes the user settings for the last disc
that you have viewed. Settings remain in memory even
if you remove the disc from the player or switch off the
player. If you load a disc that has its settings memo-
rized, the latest stop position is automatically recalled.
Notes
Settings are stored in memory for use any time.
This player does not memorize settings of a disc if
you switch off the player before commencing to play
it.
Screen Saver
The screen saver picture appears when you leave the
DVD Player in stop mode for about 15 minutes.
After the Screen Saver has been engaged for about 15
minutes, the DVD Player will automatically turn itself off.
Color System
The DVD Players color system mode is selected auto-
matically by inserted discs color system (PAL or
NTSC). When the selected system does not coincide
with the system of your TV, normal color picture may
not be displayed.
Controlling Your TV with the
Supplied Remote
You can control the sound level, input source, and
power switch of your Sony TV with the supplied remote.
You can control your TV using the buttons below.
By pressing You can
TV @ / 1 Turn the TV on or off.
22
(volume) +/ Adjust the volume of the TV.
tt
(TV/video) Switch the TVs input source
between the TV and other input
sources.
Note
Depending on the unit being connected, you may not be
able to control your TV using some of the buttons.
Controlling other TVs with the
remote
You can control the sound level, input source, and
power switch of non-Sony TVs as well. If your TV is list-
ed in the table below, set the appropriate manufacturer
code.
1. While holding down TV @ / 1, press the number
buttons to select the manufacturer code for your
TV (see the table below).
2. Release TV @ / 1.
Code numbers of controllable TVs
If more than one code number is listed, try entering
them one at a time until you find the one that works with
your TV.
Manufacturer Code Number
Sony (default) 01
Aiwa (default) 01
Grundig 11
Hitachi 24
JVC 33
LG 06
Loewe 06
Panasonic 17, 49
Philips 06, 08
Samsung 06
Sanyo 25
Sharp 29
Thomson 43
Toshiba 38
Notes
Depending on your TV, some or all buttons may not
function on the TV, even after entering the correct
manufacturer code.
If you enter a new code number, the code number
previously entered will be erased.
When you replace the batteries of the remote, the
code number you have set may be reset to the
default setting. Set the appropriate code number
again.
VCDCDDVD