Filter
Top Products
1-2
BKDW-515
4. While pushing the loosened black screws in the
direction of the arrow, remove the lower control panel
assembly from the arms.
5. Remove the screws as shown in Figure, and remove
both side arms.
6. Install the arms supplied with BKDW-515.
SLIDER AD (R) ASSY: X-3678-375-
SLIDER AD (L) ASSY: X-3678-376-
for DVW-A500, DVW500,
DVW-A500P, DVW-500P
1-2. SYS1, SYS2 ROM Versions
The control panel BKDW-515 is applicable to the ROMs
on the SS-52 board with the following version.
SYS1: 4.0 and higher
SYS2: 4.0 and higher
If the ROMs with lower version than above are used,
please contact Sony’s service organization.
Make sure the ROM’s version through the maintenance
mode before replacement of the control panel.
1-3. Removal of Control Panel /
Replacement of Arms
1. Fix a lower control panel at 90 degrees.
2. Disconnect the connector (CN580) in the system set-
up panel.
3. Loosen the two black screws on the lower control
panel. (Loosen the screws until screw’s top are
exposed from the surface of the lower control panel.)
1-2. SYS1, SYS2 ROM Versions
1-3. Removal of Control Panel / Replacement of Arms
Lower control panel
Screw(B3
x12)
CN580
System setup
panel.
Screw
(
B3x12
)
Screw
(
B3x12
)
Lower control panel
Screws
(B3x6)
Screw
(B3x6)
Arm
Screws
(B3x6)
Screw
(B3x6)
Arm