Filter
Top Products
Chapter 4 Menu Settings 4-19
Chapter 4 Menu Settings
Appears whenever a duration between
any two edit points (IN, OUT, AUDIO IN
or AUDIO OUT points) is displayed.
4-3-1 Setting the Time Data
(TIMER SEL/RESET/SET/HOLD)
The display shows the following types of time data:
2) CTL signals
CTL (control) signals are pulse signals that are recorded
horizontally in each frame.
3) User bits
Comprising a part of the time code, user bits record
supplementary information and consist of an eight-digit
number or hexadecimal A to F.
..........................................................................................................................................................................................................
1) LTC and VITC
LTC cannot be read when the tape speed is very slow or
is changed suddenly. VITC, on the other hand, can be
read more accurately than LTC when the VTR is stopped
or the tape speed is very low. VITC, however, cannot be
read when the tape speed is very fast.
Indication Time data type
The LTC
1)
value read by the time code
reader during playback.
TCR VITC The VITC
1)
value read by the time code
reader during playback.
CTL The number of CTL signals
2)
on the tape
during recording/playing.
UBR LTC The user bits
3)
value read by the time
code reader (LTC) during playback.
UBR VITC The user bits value read by the time code
reader (VITC) during playback.
UBG
The value generated by the time code
generator during recording.
The user bits value generated by the time
code generator during recording.
DUR
Indication Time data type
IN Time data for an IN point.
OUT Time data for an OUT point.
Time data for an AUDIO IN point.
AUDIO IN
AUDIO OUT Time data for an AUDIO OUT point.
TCG
Time data for IN, OUT, AUDIO IN and AUDIO OUT
points are also displayed.
Selecting the time data display
Press the [F1] (TIMER SEL) button repeatedly to
select the desired time data display.
CTL: Counts the CTL signals on the playback tape
or the CTL signals being recorded on the tape, and
displays the tape running time in hours, minutes,
seconds, and frames.
TC: Displays the value read by the time code reader
or the value generated by the time code generator.
To switch between VITC and LTC, press the [F5]
(TC SEL) button.
UBIT: Displays user bits data inserted in time code
being played back, or the user bits data inserted in
time code being recorded. To switch between
VITC and LTC, press the [F5] (TC SEL) button.
TCR LTC
ÅIN 00:00:00:00 ÅOUT 00:00:00:00
LOCK
DOLBY
NR
TIMER
SEL
TC
CH.COND
GREEN
DIGITÅL
TC
TCR VITC PLAY DF 4FD F1
IN 00:00:00:00 OUT 00:00:00:00
01Ó 04µ 58ß 00ƒ
TIMER
RESET
TIMER
SET
TIMER
HOLD
off
TC
SEL
VITC
TCG
SOURCE
int
TCG
MODE
prst
RUN
MODE
rec
DF/NDF
DF
VITC
on
Time data for
edit points