Sony HDW-2000 VCR User Manual


 
Chapter 5 Editing
Chapter 5 Editing 5-15
Notes
In preread editing, if an input video signal is used as
the reference signal for the output video signal, this
forms a feedback loop. To prevent the occurrence of
feedback, set the F2 (OUTREF)(see page 9-7) in
function menu page 4 to REF, and set item 309 in the
extended setup menu to AUTO1 (see page 10-15) so
as to use an external reference signal.
•When the preread mode is selected, to prevent
feedback due to the loop connection, whatever the
editing mode of this unit, no E-E video output is
available.
When the PREREAD is set to OFF after preread
editing, however, if the loop connection remains and
an E-E signal is output, feedback will occur.
To prevent this, select PB mode for the video and
digital audio channels in all the modes before the
preread editing, as follows.
1 Set F2 (PB/EE) in function menu HOME page to
PB.
2 Set the F6 (PREREAD)(see page 9-7) in function
menu page 4 to ON.
3 Make the necessary connections for the preread
editing.
4 After selecting the desired insert editing mode,
carry out the preread editing.
5 When the preread editing is completed, remove the
connections.
6 Set the PREREAD to OFF.
7 Check that no loop connection remains.