Filter
Top Products
30
GB
PC Adjustment
Customises the TV screen as a PC monitor.
z
• This option is only available if a PC signal is received.
• “Auto Adjustment” may not work well with certain input signals. In such cases, manually
adjust “Phase”, “Pitch”, “Horizontal Shift”, and “Vertical Shift”.
“Screen Format”: Select “Normal” to display in the original image size. Select
“Full 1” to enlarge the picture to fill the display area, keeping its original aspect ratio.
Select “Full 2” to enlarge the picture to fill the display area.
“Reset”: Resets all the “PC Adjustment” except “Screen Format” to the factory
settings.
“Auto Adjustment”: Automatically adjusts the display position, and phase of the
picture in PC mode.
“Phase”: Adjusts the screen when a part of a displayed text or image is not clear.
“Pitch”: Enlarges or shrinks the screen size horizontally.
“Horizontal Shift”: Moves the screen to the left or to the right.
“Vertical Shift”: Moves the screen up or down.
Channel Set-up
Analogue Set-up
“Analogue Auto Tuning” (Only in analogue mode): Tunes in all the available
analogue channels. Usually you do not need to do this operation because the
channels are already tuned when the TV was first installed. However, this option
allows you to repeat the process (e.g., to retune the TV after moving house, or to
search for new channels that have been launched by broadcasters).
“Manual Programme Preset” (Only in analogue mode): Changes the available
analogue channel setting.
Press to select the programme you want to modify.
System
Presets programme channels manually.
1 Press
F/f to select “System”, then press .
2 Press
F/f to select one of the following TV broadcast systems, then
press .
B/G: For western European countries/regions
I: For the United Kingdom
D/K: For eastern European countries/regions
L: For France
~
• Depending on the country/region selected for “Country”, this option may not be available.
Channel
1 Press
F/f to select “Channel”, then press .
2 Press
F/f to select “S” (for cable channels) or “C” (for terrestrial
channels), then press
g.
3 Tune the channels as follows:
If you do not know the channel number (frequency)
Press F/f to search for the next available channel. When a channel has been found,
the search will stop. To continue searching, press F/f.
If you know the channel number (frequency)
Press the number buttons to enter the channel number of the broadcast you want or
your VCR channel number.
4 Press to jump to “Confirm”, then press .
Repeat the procedure above to preset other channels manually.