Sony KDL-40S4100 Flat Panel Television User Manual


 
Getting Started
20
2 Secure the TV to the Stand.
Use the optional hardware listed below (not supplied):
M6 × 12-18mm anchor bolt (screwed into the TV’s Table-Top Stand).
A screw or similar (attach it to the TV stand).
Rope or chain (strong enough to support the weight of the TV). Make
sure that there is no excess slack in the rope or chain.
An alternative way to secure the TV is with an optional Sony Support Belt Kit.
3 Anchor the TV to the Wall.
Use the hardware listed below (not supplied).
Two M6 × 12-18mm anchor bolts (screw into the top-most wall-
mount holes located on the rear of the TV).
Rope or chain (attach to one M6 anchor bolt).
Wall-anchor (attach to the wall stud) strong enough to support the
weight of the TV (pass the rope through the wall-anchor, then attach
to the other M6 anchor bolt).
Contact Sony Customer Support to obtain the optional Support Belt Kit
by providing your TV model name.
For United States call: 1-800-488-7669
or visit: www.sony.com/accessories
For Canada call: 1-877-899-7669
Measure 2 provides minimal protection against the TV toppling over.
For further protection, follow all three measures recommended above.
If an electric screwdriver is used, set the torque to tighten at
approximately 2.0 N·m {20 kgf·cm}.
Screw hole on the
Table-Top Stand
Anchor bolt
Screw
Wall-mount
holes
Anchor bolts
Wall-anchor
Rope or
chain