Sony KDL-40Z4500 Flat Panel Television User Manual


 
47
GB
Using MENU Functions
Manual Programme
Preset
Before selecting “Label/AFT/Audio Filter/LNA/Skip/Decoder”, press PROG +/–
to select the programme number with the channel. You cannot select a programme
number that is set to “Skip” (page 44).
System/Channel Presets programme channels manually.
1 Press F/f to select the programme number you want to
manually tune (if tuning a VCR/ DVD recorder, select
channel 00), then press .
2 Press F/f to select “System”, then press .
3 Press F/f to select one of the following TV broadcast
systems, then press .
B/G: For western European countries/regions
I: For the United Kingdom
D/K: For eastern European countries/regions
L: For France
4 Press F/f to select “Channel”, then press .
5 Press F/f to select “S” (for cable channels) or “C” (for
terrestrial channels), then press g.
~
“S” is not available when “United Kingdom” is
selected for “Country” (page 6).
6 Tune the channels as follows:
If you do not know the channel number
(frequency)
Press F/f to search for the next available channel. When
a channel has been found, the search will stop. To
continue searching, press F/f.
If you know the channel number (frequency)
Press the number buttons to enter the channel number of
the broadcast you want or your VCR/DVD recorder
channel number.
7 Press to jump to “Confirm”, then press .
Your changes have been saved. Repeat the above
procedure to preset other channels manually.
Label Assigns a name of your choice, up to five letters or numbers,
to the selected channel. This name will be displayed briefly
on the screen when the channel is selected.
To input characters, follow steps 1 to 3 of “Edit” (page 44).
AFT Allows you to fine-tune the selected programme number
manually if you feel that a slight tuning adjustment will
improve the picture quality.
You can adjust the fine tuning over a range of –15 to +15.
When “On” is selected, the fine tuning is performed
automatically.
Audio Filter Improves the sound for individual channels in the case of
distortion in mono broadcasts. Sometimes a non-standard
broadcast signal can cause sound distortion or intermittent
sound muting when watching mono programmes.
If you do not experience any sound distortion, we
recommend that you leave this option set to the factory
setting “Off.”
~
You cannot receive stereo or dual sound when “Low” or
“High” is selected.
(Continued)