Filter
Top Products
[3D Glasses Brightness]
Sets the image brightness when using the 3D display mode. By
selecting [Auto], image brightness through the Active 3D Glasses is
automatically adjusted in conjunction with the [Picture Mode] setting.
[Auto 3D]
Select [Auto 1] to switch the 3D display mode automatically when a 3D
signal is detected.
If no 3D signal is detected, select [Auto 2], which will analyze the image
for 3D information and switch the 3D display mode automatically.
Select [Off] to prevent the 3D display mode from being automatically
selected.
Depending on the input signal or format, the 3D display mode may not
switch automatically.
In such a case, press the 3D button to select the 3D display mode
manually.
(When using the Touchpad Remote Control, press the Control Bar (
),
slide the touchpad to highlight the 3D button, then press the touchpad to
select.)
[3D Signal Notification]
Notifies when a 3D signal is detected.
To replace the battery
If the LED indicates low battery power (indicator blinks green 3 times
every 2 seconds), replace the battery. Use a CR2025 battery only.
Press the unlock button with the tip of a pen, etc, and take out the
battery case, then replace the battery with a new one. After that, be
sure to lock the battery case again.
Tips
If you wear glasses, remove the nose pad from the Active 3D Glasses by
pulling it down, then wear them over your glasses.
Notes
3D effect is available only when pictures are displayed in full screen.
If [Motionflow] is set to other than [Off], the smooth movement of the
picture may be lost as the picture process to minimize screen flicker is
applied. In such a case, set [Motionflow] to [Off] to display the original
66