Filter
Top Products
44
GB
Programme Labels Assigns a channel name of your choice, up to five letters or numbers. The name
appears briefly on the screen when you select the channel.
1 Press F/f to select the channel you want to name, then press .
2 Press F/f to select the desired letter or number (“_” for a blank space), then
press g.
If you enter a wrong character
Press G/g to select the wrong character. Then, press F/f to select the correct
character.
3 Repeat step 2 until you complete the name.
4 Press to exit the labeling procedure.
Programme Block Blocks an individual channel from being watched.
1 Press F/f to select the channel you want to block, then press .
2 Press F/f to select “Block”, then press .
To watch the channel, select “Allow”.
Intelligent Picture On with Indicator Automatically reduces the picture noise. The signal level bar
is displayed when the channel is changed or the display is
changed from an input screen to a TV programme.
On Automatically reduces the picture noise.
Off Turns off the “Intelligent Picture” feature.
Manual Programme
Preset
To preset a channel, press PROG +/– to select the programme number, before
selecting “Label”, “AFT”, “Audio Filter”, “Skip”, “LNA” or “Colour System”.
You cannot select a programme number that is set to “Skip” (page 45).
Programme/
TV System/
Frequency
Presets programme channels manually.
1 Press F/f to select “Programme”, then press .
2 Press F/f to select the programme number you want to
manually tune (if tuning a VCR, select programme 0),
then press .
3 Press F/f to select “TV System”, then press .
4 Press F/f to select the best received TV broadcast
systems, then press .
5 Press F/f to select “Frequency”, then press .
6 Press G/g to search for the next available channel. The
frequency band (“VHF Low”, “VHF High” or “UHF”)
is changed accordingly.
Label Assigns a name of your choice, up to five letters or numbers,
to the selected channel. This name appears briefly on the
screen when you select the channel.
To input characters, follow steps 2 to 4 in “Programme
Labels” (page 44).
AFT Allows you to fine-tune the selected channel manually if you
feel that a slight tuning adjustment may improve picture
quality.
You can adjust the fine tuning over a range of –15 to +15.
When “On” is selected, fine tuning adjustments are made
automatically.