Sony KDL-40S20L1 TV VCR Combo User Manual


 
Other Information
42
No sound/Noisy sound
Good picture, no sound.
Check the volume control.
Press MUTING or VOL + so that “Muting” disappears from the screen
(page 20).
Disconnect your headphones.
Set Speaker to On in the Setup settings (page 34). If it is set to Off, sound is
not output from the TV’s speakers regardless of the TV’s volume control.
Audio noise.
Make sure that the antenna is connected using the supplied 75-ohm coaxial
cable.
Keep the antenna cable away from other connecting cords.
To avoid TV interference, make sure to use an undamaged antenna cable.
Wide Mode changes automatically.
The current
Wide Mode
setting is automatically replaced with the
4:3 Default
setting when you change the channel or video input, if
4:3 Default
in the
Screen
settings is set to other than
Off
. If you want to lock in the
Wide Mode
selected
with the
WIDE
button, set
4:3 Default
to
Off
in the
Screen
settings (page 30).
Check the Auto Wide option in the Screen settings (page 29).
“Black box” on screen.
You have selected a text option in the Setup/Digital Setup setting and no text is
available. (See pages 31 and 39 to reset Setup selections.) To turn off this feature,
set the Caption Vision option to Off. If you were trying to select closed
captioning, select CC1 instead of Text 1-4.
Black bands appear at the top and
bottom of the screen.
Some wide screen programs are filmed in aspect ratios that are greater than 16:9
(this is especially common with theatrical releases). Your TV will show these
programs with black bands at the top and bottom of the screen. For more details,
check the documentation that came with your DVD (or contact your program
provider).
Certain programs on DVD or other
digital sources display a loss of
detail, especially during fast-motion
or dark scenes.
The compression used by certain digital broadcasts and DVDs may cause your
TV’s screen to display less detail than usual, or cause artifacts (small blocks or
dots, pixelations) to appear on your screen. This is due to your TV’s large screen
and ability to show very fine detail, and is normal for certain digitally recorded
programs.
Remote control does not operate.
Check the polarity of the batteries or replace the batteries.
Point the remote control at the remote control sensor of the TV.
Florescent lamps can interfere with your remote control operation; try turning
off the florescent lamps.
Keep the remote control sensor area clear from obstacles.
Some digital cable channels are not
being displayed.
Certain cable companies have limitations on the broadcast of digital cable
channels. Check with your cable company for more information.
The digital cable channel may be set to Hidden in the Show/Hide Channels
setting (see page 38).
Lost password. Select the Parental Lock settings on the settings screen, then enter the following
master password: 4357. The master password clears your previous password and
allows you to enter a new password (page 32).
How to reset the TV to factory
settings.
Turn on the TV. While holding down the V button on the remote control, press
the POWER button on the TV. (The TV will turn itself off, then back on again.)
Release the
V button.
WARNING: The Reset will clear all of your customized settings including
Parental Lock setting.
Problem Possible Remedies