Sony KDS-60A3000, KDS-50A3000, KDS-55A3000 Projection Television User Manual


 
13
Getting Started
3. Connecting the TV
You can enjoy high-definition and standard-
definition digital programming (if available in
your area) along with standard-definition analog
programming.
~
This TV is capable of receiving unscrambled digital
programming for both cable (QAM and 8VSB) and
external VHF/UHF antenna (ATSC).
It is strongly recommended that you connect the
antenna/cable input using a 75-ohm coaxial cable to
receive optimum picture quality. A 300-ohm twin lead
cable can be easily affected by radio frequency
interference, resulting in signal degradation.
Cable or VHF/UHF (or VHF only)
Use an optional A-B RF switch (not supplied) to
switch between the cable and over-the-air antenna
programming, as indicated below.
~
Be sure to set the Cable setting to On or Off in the
Channel settings for the type of input signal you
choose (see page 39).
You can also enjoy high-definition programming
by subscribing to a high-definition cable service or
a high-definition satellite service. For the best
possible picture, make sure you connect this
equipment to your TV via the HDMI or
component video (with audio) input on the back of
your TV.
Cable System or VHF/UHF Antenna
System
Cable System and VHF/UHF Antenna
System
75-ohm coaxial
cable
Side of TV
VHF/UHF/CABLE input
B
A
Cable
Antenna
A-B RF switch
Side of TV
VHF/UHF/CABLE input
HD Cable Box/HD Satellite Box
1
2
3
PC IN
LR
AUDIO AUDIO
RGB
HD cable box/
HD satellite box
Side of TV
HDMI cable
Shown with HDMI Connection
CATV/Satellite
antenna cable
(Continued)