Filter
Top Products
Watching the TV
34
Programming the Remote Control
The remote control is preset to operate Sony brand video equipment.
Follow the steps below to program your TV’s remote control to operate the
other video equipment.
Find the three-digit code for your equipment from the “Manufacturer’s
Codes” listed on page 35. If more than one code number is listed, try
entering from the code listed first.
1 Press and hold the or FUNCTION button you want to
program on the remote control and press the button simultaneously.
The selected FUNCTION button (DVD/VCR or SAT/CABLE) will
flash.
2 Enter the three-digit manufacturer’s code number using the --9
buttons while the button is lit, approximately 10 seconds.
3 Press button.
When the programming is correct, the selected FUNCTION button will
flash twice slowly, and when not, flashes five times quickly.
To check if the code works
Aim your TV’s remote control at the equipment, and press the green
POWER button. If the equipment responds, the programming is completed.
If not, try the next code listed.
Sony Equipment Programmable Code Number
DVD/VCR 601 (Sony Dream System)
SAT/Cable 801 (Sony Satellite Receiver)
If no code is input within the above specified time, or an invalid or
incorrect code number is input, the remote control automatically goes
back to the previous setting.
In some cases, you may not be able to program your remote control to
operate other equipment. In such cases, use the equipment’s own
remote control.
Dead batteries or removing the batteries may cause the programmable
codes to be lost and revert back to factory settings. Reprogramming the
codes may be necessary.
Insert two size AA batteries
(supplied) by matching the
e and E on the batteries to
the diagram inside the
remote control’s battery
compartment.
MUTING DISPLAY
FREEZE
MTS/
SAP
POWER
SAVING
TOP MENU MENU GUIDE SLEEP
F1
FUNCTION
F2
TV/
VIDEO
POWER
RETURN
SOUND PICTURE WIDE
TV/SAT
MODE
WEGA GATE
1
1
3
2
DISPLAY