Filter
Top Products
56
D:\810nouhin\4080199111\408019911KP57XBRUC\02US-COV-KP57XBRUC\10OVE.fm masterpage:Left
Model name1[KP-57XBR10W] Model name2[KP-65XBR10W]
[4-080-199-11 (1)]
Operating a Cable Box
or Satellite Receiver
(SAT)
You can program the supplied remote control to
operate a cable box or satellite receiver.
Press CODE SET, SAT/CABLE (FUNCTION),
and the 0-9 buttons to enter the manufacturer’s
code number (see the following chart), then press
ENTER.
For example, to operate a Sony satellite receiver:
Manufacturer code numbers (cable
Manufacturer code numbers (cable Manufacturer code numbers (cable
Manufacturer code numbers (cable
box)
box)box)
box)
Manufacturer code numbers
Manufacturer code numbers Manufacturer code numbers
Manufacturer code numbers
(Satellite receiver)
(Satellite receiver)(Satellite receiver)
(Satellite receiver)
1
Press SAT/CABLE (POWER) [Green Button]
to turn on/off the cable box or satellite receiver.
2
Press SAT/CABLE (FUNCTION).
3
For other operations, refer to the operating
instructions that come with the equipment.
Blue-labeled buttons such as the GUIDE
button can be used only with a satellite
receiver.
If the remote control doesn’t work
If the remote control doesn’t workIf the remote control doesn’t work
If the remote control doesn’t work
• Try repeating the set up procedures using the
other codes listed for your equipment.
To operate the projection TV
To operate the projection TVTo operate the projection TV
To operate the projection TV
Press TV (FUNCTION). Then use the projection
TV control buttons to control the projection TV.
Tips z
• If more than one code number is listed, try entering
them one by one until you come to the correct code
for your equipment.
• If you enter a new code number, the code number
you previously entered at that setting is erased.
• In some rare cases, you may not be able to operate
your equipment with the supplied remote control. In
this case, use the equipment’s own remote control
unit.
• Whenever you remove the batteries — to replace
them, for example — if too much time is taken, the
code numbers may revert to the factory setting and
must be reset.
Setting the Manufacturer’s
Code
1
8
0
CODE SET
ENTER
SAT/CABLE
FUNCTION
Manufacturer Code
Gemini 233
Hamlin/Regal 222, 223, 224, 225, 226
Jerrold/G. I. 201, 202, 203, 204, 205, 222,
206, 207, 208, 218
Macom 230, 231, 232
Magnavox 234
Oak 227, 228, 229
Panasonic 219, 220, 221
Philips 236, 237, 238, 239, 240, 241
Pioneer 214, 215
Samsung 235
Scientific Atlanta 209, 210, 211
Tocom 216, 217
Zenith 212, 213
Manufacturer Code number
Sony 801 (preset code for remote
control)
General Electric 802
RCA/PROSCAN 802
Operating a cable box or
satellite receiver