Filter
Top Products
— 8 —
KV-27S42/27S46/27S66/29AL42/29AL42C/29AL66/
29AL66C/29SL42/29SL42C/29SL46/29XL42M
The following are partial abstracts from the Operating Instruction
Manual. The page numbers shown reflect those of the Operating
Instruction Manual.
SECTION 1
GENERAL
Connecting Your TV
This section covers basic connections in addition to any optional
equipment you may be connecting.
Basic Connections
TV with indoor or outdoor antenna, or CATV cable
Depending on the cable available in your home, choose one of the
connections below:
Cable and antenna
KV-27S66, 27V66 only
If your cable provider does not feature local channels, you may find this
set up convenient.
✍ If you are connecting to an indoor or outdoor antenna, it will be necessary to
adjust the orientation of the antenna for best reception.
✍ Select CABLE or ANT mode by pressing on the remote control.
CATV cable
(No connection “TO
CONVERTER” in this case)
Antenna cable
VHF/UHF
TO CONVERTER
AUX
(Rear of TV)
User Guide
Connecting Additional Equipment
TV and VCR
1
Connect the coaxial cable from your TV antenna or cable TV to the IN
jack on your VCR.
2
Connect a coaxial cable (not supplied) from the OUT jack on your
VCR to the VHF/UHF IN jack on the TV.
(Optional connection)
3
If your VCR is equipped with video inputs, for better picture quality
you should connect A/V cables to AUDIO and VIDEO OUT on your
VCR to AUDIO/VIDEO IN on your TV. You can use the button
to switch between the TV and VCR inputs.
!
VCR must be connected and turned on to operate PIP. (KV-27S46 only)
✍ To watch video programs from your VCR, tune your TV to channel 3 or 4 (as
set on the rear of your VCR).
✍ For optimum picture quality, use S VIDEO instead of the yellow A/V cable.
S VIDEO does not provide sound, the audio cables must still be connected.
(Optional connection)
From
Cable/
VCR
TV
2
1
3
antenna
Connecting Your TV
TV and Cable Box
1
Connect the coaxial cable from the wall to the IN jack on your cable
box.
2
Connect a coaxial cable (not supplied) from the OUT jack on your
cable box to the VHF/UHF IN jack on the TV.
✍
To view channels from your cable box, tune your TV to channel 3 or 4 (as set
on the rear panel of your cable box).
✍
If you will be controlling all channel selection through your cable box, you
should consider using the CHANNEL FIX feature on page 24.
User Guide
TV, Cable box and Cable
KV-27S66, 27V66 only
For this set up, you can switch between scrambled channels (through
your cable box), and normal (CATV) channels by pressing on your
remote control.
✍
When using PIP, the AUX input cannot be viewed in the window picture.
(Rear panel KV-27V66 only)
5 6
3 4