Filter
Top Products
— 16 —
**WARNING: Do NOT turn off the power or AC immediately after pressing then . Wait at least 10 seconds.
KV-32S40/32S45/34SL40/34SL40C/34SL40T/34SL45/35S40/35S45/37SL45/
32V40/32V65/34VL65/34VL65C/35V65/37VL65/37VL65C
ELECTRICAL ADJUSTMENT BY REMOTE COMMANDER
NOTE : Test Equipment Required:
1. Pattern Generator
2. Frequency Counter
3. Digital Multimeter
4. Audio OSC
(1) Method of Setting the Service
Adjustment Mode
SERVICE MODE PROCEDURE
1. Standby mode. (Power off)
2.
on the
Remote Commander.
(Press each button within a second.)
SERVICE ADJUSTMENT MODE IN
3. The CRT displays the item being adjusted.
4. Press
or on the Remote Commander to select the item.
5. Press
or on the Remote Commander to change the
data.
6. Press
then to write into memory**.
SERVICE ADJUSTMENT MODE MEMORY
Green
7. Press
then on the Remote Commander to
initialize.
SECTION 5
CIRCUIT ADJUSTMENTS
Disp.
(Item)
Item
data
SERVICE AFC 0
Use Remote Commander (RM-Y167) to perform the following circuit adjustments:
Red
SERVICE RESET
RM-Y167
Carry out step 7 when adjusting
IDs 0 to 4 and when replacing
and adjusting IC002.
SERVICE WRITE
8. Turn set off and on to exit. * CAUTION: Wait at least
10 seconds before turning off set.
(3) Adjust Buttons and Indicator
(2) Memory Write Confirmation Method
1. After adjustment, pull out the plug from the AC outlet,
then replace the plug in the AC outlet again.
2. Turn the power switch ON and set to Service Mode.
3. Call the adjusted items again to confirm they were adjusted.