Filter
Top Products
Connecting an aerial and VCR to the TV
1
1.
Connect your aerial lead to the IN* socket on your VCR.
2.
Connect an RF lead from the OUT* socket on your VCR to the aerial socket
labelled 8 on the rear of the TV.
3.
Connect a fully wired 21-pin scart lead from the scart socket marked
i3/r3 on the rear of the TV to a scart socket on your VCR**
Notes: *Socket names may vary depending on make and model of VCR. Refer to your VCR
instruction manual for details.
**If your VCR does not have a scart socket follow the connecting instructions above
ignoring the scart lead connection.
You will also need to manually tune the VCR to a spare TV channel (ideally channel 0,
refer to the ‘Manual Programme Preset menu’ section of the main instruction manual).
1.
Connect your aerial lead to the aerial socket labelled 8 on the rear of the TV.
Connecting an aerial only
Quick Start Guide
4-089-904-01
2
Inserting batteries into
the remote control
Always remember to:
• observe the correct polarity when inserting batteries,
• dispose of batteries in an environmentally friendly way.
1
KV-36FS76U
This step by step guide will help you to:
Connect an aerial to the TV,
Connect a video cassette recorder (VCR) to the TV,
Insert batteries into the remote control,
Switch on the TV,
Tune the TV,
Watch TV programmes,
Watch video tapes.
Thank you for choosing this
Sony Trinitron Television.
Switching on the TV
3
1.
Connect the TV plug to your mains socket and switch on.
2.
The TV is usually switched on. If not, push in the On/Off button ! on the front
of the TV.
If the red standby mode indicator on the front of the TV is lit, press the
TV I/1 button on the remote control to switch on the TV set. Please be
patient as the picture may take a few moments to appear on the TV screen.
3
2
© 2002 Sony Corporation
RF lead
(not supplied)
IN
OUT
VCR
Scart lead
(not supplied)
On/Off button