Filter
Top Products
34 Additional Information
continued
No picture
No sound
Good picture
No sound
Dotted lines or
stripes
Double images or
“ghosts”
No color
Possible causeSymptom Solutions Page
• The power cord,
antenna or VCR is not
connected.
• The TV is not turned
on.
• The volume level is too
low.
• The sound is muted.
• PIP sound is selected
when PIP is displayed.
• There is local
interference from cars,
neon signs, hair dryers,
power generators, etc.
• Broadcast signals are
reflected by nearby
mountains or
buildings.
• The antenna setup is
inappropriate.
• Use of a booster is
inappropriate.
• The color level setting
is too low.
• The color system
setting is
inappropriate.
• The antenna setup is
inappropriate.
• Check the power cord, antenna and VCR
connections.
• Press
?/1
(power).
• Press ! (main power) on the TV to turn
off the TV for about five seconds, then
turn it on again.
• Press 2 + to increase the volume level.
• Press % to cancel the muting.
• Press SOUND or .
• Do not use a hair dryer or other
equipment near the TV.
• Check the antenna setup. Contact a Sony
dealer for advice.
• Use a highly directional antenna.
• Use the fine tuning (“FINE”) function.
• Check the antenna setup. Contact a Sony
dealer for advice.
• Turn off or disconnect the booster if it is in
use.
•
Display the “PICTURE” menu and select
“ADJUST” of “PICTURE MODE”, then
adjust the “COLOR” level.
• Display the “SETUP” menu and check the
color system (“COLOR SYS”) setting
(usually set this to “AUTO”).
• Check the antenna setup. Contact a Sony
dealer for advice.
31
9
8
9
9
13
–
–
–
30
–
–
22
26
–