Filter
Top Products
– 15 –
KV-G14M2
RM-869
3-4. a. AN ITEM OF ADJUSTMENT
b. METHOD OF CANCELLATION FROM SERVICE
MODE
Set the standby condition (Press
POWER
button on the
commander) and then press
POWER
button again, hereupon it
becomes TV mode.
c. METHOD OF WRITE FOR MEMORY
1) Set to Service Mode.
2) Press 1 (UP) and 4 (DOWN) to select an item of adjustments.
3) Press
MUTING
button and it will indicate WRITE on screen.
4) Press - button to write into memory.
d. MEMORY WRITE CONFIRMATION METHOD
1) After adjustment, pull out the plug from AC outlet, and then
plug into AC outlet again.
2) Turn the power switch ON and set to Service Mode.
3) Call the adjusted items again, confirm they were adjusted.
Note
WHITE POINT R
WHITE POINT G
WHITE POINT B
Initial DATA
25
20
20
3-5. G2 (SCREEN) AND WHITE BALANCE
ADJUSTMENTS
1. G2 (SCREEN) ADJUSTMENT (RV701)
1) Set the PICTURE and BRIGHTNESS to normal.
2) Put to VIDEO input mode without signals.
3) Connect R, G and B of the C board cathode to the oscilloscope.
4) Adjust G2 (RV701) volume to the value below.
Item
number
09
0A
0B
Adjustment
Item
RDR
GDR
BDR
165 ± 2 V DC
2. WHITE BALANCE ADJUSTMENTS
1) Set to Service Mode.
2) Input an entire white signal.
3) Set the PICTURE to maximum.
4) Select RDR(09) with 1 and 4 , and then set the level to 25
with 3 and 6 .
5) Select GDR(0A) and BDR(0B) with 1 and 4, and adjust
the level with 3 and 6 for the best white balance.
6) Write into the memory by pressing
MUTING
, then - .
SERVICE
MUTING
1 FRDR09
6000V3.2C052S
6000V3.2C052S
OEM CODE
PAL or
NTSC
German A2 Stereo
Software Version #
WRITE1 FRDR09
0
Executes the writing
Green
WRITE1 FRDR09
0
Executes the writing
(bottom line disappears)
0
V