Filter
Top Products
Additional Information
24
• Check the antenna cable and connection
on the TV, VCR and on the wall.
• Press SELECT until “MANUAL
PROGRAM” appears on the screen, then
preset the channel again.
• Check the antenna type (VHF/UHF).
Contact a Sony dealer for advice.
• Adjust the antenna direction. Contact a
Sony dealer for advice.
• Try using a booster.
• Turn off or disconnect the booster if it is
in use.
• If the sound of some channels are noisy,
select the channel, then select the
appropriate TV system (TV SYS).
• Check the power cord, antenna and the
VCR connections.
• Press ?/1 (power).
• Press ! (main power) on the TV to turn
off the TV for about five seconds, then
turn it on again.
Snowy picture
Noisy sound
Distorted picture
Noisy sound
Good picture
Noisy sound
No picture
No sound
Troubleshooting
If you find any problem while viewing your TV, please check the following guide. If
any problem persists, contact your Sony dealer .
Possible causeSymptom
Solutions
• Connection is loose or
the cable is damaged.
• Channel presetting is
inappropriate or
incomplete.
• The antenna type is
inappropriate.
• The antenna direction
is inappropriate.
• Signal transmission is
low.
• Broadcast signals are
too strong.
• The TV system setting
or channel presetting
is inappropriate or
incomplete.
• The power cord,
antenna or VCR is not
connected.
• The TV is not turned
on.
Page
4
11
–
–
–
–
11
4
14
13