Filter
Top Products
31
Additional Information
GB
Remote Control Configuration for VCR/DVD
This remote control is set by default to operate basic functions of this Sony TV, Sony DVD and
most Sony VCRs when batteries are initially installed. To control other VCRs and DVDs of other
major brands and certain Sony VCR models, please complete the following steps:
1 Press the Media Selector button on the remote control repeatedly
until the required VCR or DVD green light is lit.
If Media Selector is in the TV position, code numbers will not
be stored.
2 Before the green light goes out, press and hold the yellow button for
approximately 6 seconds until the green light starts flashing.
3 Whilst the green light is flashing, enter all three digits of the code for
your brand using the number buttons on the remote control.
If your selected code is entered correctly, all three green lights
will be lit momentarily.
4 Turn on your VCR or DVD and check that the main functions work.
VCR Brand List DVD Brand List
Brand Code Brand Code
SONY (VHS) 301, 302, 303, 308, 309 SONY 001
SONY (BETA) 303, 307, 310 AIWA 021
SONY (DV) 304, 305, 306 DENON 018, 027, 020, 002
AIWA 325, 331, 351 GRUNDIG 009, 028, 023, 024, 016, 003
AKAI 326, 329, 330 HITACHI 025, 026, 015, 004
DAEWOO 342, 343 JVC 006, 017
GRUNDIG 358, 355, 360, 361, 320, 351 KENWOOD 008
HITACHI 327, 333, 334 LG 015, 014
JVC 314, 315, 322, 344, 352, 353, LOEWE 009, 028, 023, 024, 016, 003
354, 348, 349 MATSUI 013, 016
LG 332, 338 ONKYO 022
LOEWE 358, 355, 360, 361, 320, 351 PANASONIC 018, 027, 020, 002
MATSUI 356, 357 PHILIPS 009, 028, 023, 024, 016, 003
ORION 328 PIONEER 004
PANASONIC 321, 323 SAMSUNG 011, 014
PHILIPS 311, 312, 313, 316, 317, 318, 358, 359 SANYO 007
SAMSUNG 339, 340, 341, 345 SHARP 019, 027
SANYO 335, 336 THOMSON 012
SHARP 324 TOSHIBA 003
THOMSON 319, 350 YAMAHA 018, 027, 020, 002
TOSHIBA 337
• Before you start, look up the 3 digit code for your brand of DVD or VCR from the list
below. On those brands that have more than one code, enter the first code number.
• Sony will endeavour to update the software according to market changes. Therefore,
please refer to code table included with the remote control for latest code set.
• If your device is not working or some of the functions do not
work please check you entered the correct code set or try the
next code listed against the brand.
• Your brand codes may be lost if weak batteries are not
replaced within a few minutes. To reset your DVD or VCR
code number please repeat the above steps. A small label is
attached inside the battery door to allow you to record your
brand codes.
• Not all brands are covered and not all models of every brand
may be covered.
/
TVVIDEO
OK
DVDVCR
123
456
789
0
PROG
TV
MENU REC
2
1
3