Filter
Top Products
126
3
Press the [MACRO VIEWER] key.
4
Press the Component key or a Direct
Access button whose macro you
want to check.
The macro procedure is shown in the
display in order. When showing is
complete, the display returns to step 4.
Notes
•You cannot select a Component key for which no macro is programmed.
• The macro procedures of the [JUMP] key and the [DELAY] key are not displayed.
■ To manually check the programmed macro procedure in order
Press the [PAUSE] key to suspend consecutive showing. Press the [PAUSE]
key again to resume consecutive showing.
While consecutive showing is suspended, press the NEXT button to show
the next macro step and press the BACK button to show the previous step.
5
To finish all settings, press the COMMANDER OFF button for 2
seconds or longer.
The display returns to the Home display. Or press the [EXIT] key repeatedly
until the Home display is shown.
Continued
Programming a series of actions (macro) for a key/button