Filter
Top Products
181
Easy selection of a series of actions
(macro) programmed for Zapping (ZAPPING)
5
Program a macro procedure
for the Zapping element.
For details on programming a macro
procedure, see steps 1 - 4 in “Step 2:
Setting a macro” (pages 120 - 121).
z Tip
Up to 128 steps (actions) can be programmed
for one Zapping element. However, the
number of steps (actions) that you can
program may be less than 128 depending on
the free memory capacity of the Remote
Commander.
6
Press the [OK] key.
A macro procedure is stored in memory
for the Zapping element.
Note
If you press the [CANCEL] key, a macro set to
the Zapping element will be canceled.
7
Press the [OK] key.
A macro procedure is programmed for
the Zapping element, and the display
returns to the Set display (step 2 on page
176).
Note
If you press the [CANCEL] key, a macro set to
the Zapping element will be canceled.
To finish the setting
Press the COMMANDER OFF button for 2 seconds or longer. The display returns
to the Home display. The setting finishes.
Programming of the Zapping group, element and macro is complete.