Filter
Top Products
202
Reading data saved in a “Memory Stick”
(READ)
You can import data set up with the supplied application or the latest remote
control codes downloaded from a web site to the Remote Commander from
“NAVITUS Design” using a “Memory Stick.”
The following data can be saved to a “Memory Stick” using a computer. *
1)
• All environment data (all data of the Remote Commander)
• Latest remote control code (preset code) and its image data
• Data for each component
*
1)
A single “Memory Stick” can contain only one of the above.
• For details on how to save data to the “Memory Stick” from a computer, refer to
“Exporting the settings by NAVITUS Design to a Memory Stick” (“NAVITUS Design”
manual (Help)).
• The data saved by any application other than “NAVITUS Design” cannot be read.
The procedure explained here is for when the “Memory Stick” detection
message appears after inserting a “Memory Stick.”
1
Insert a “Memory Stick” into the “Memory Stick”
slot of the Remote Commander.
For details, see “Inserting a “Memory Stick”” (page 200).
2
Press the [READ] key.
z Tip
If you press the [CLOSE] key, the display returns to the previous one without
reading.