Filter
Top Products
207
Using a “Memory Stick”
Saving Remote Commander data to a
“Memory Stick” (SAVE)
You can save all data set up with the Remote Commander to a “Memory Stick.”
This function is useful when backing up the data or transferring all data set up
with the Remote Commander to a computer via a “Memory Stick.”
The procedure explained here is for when the “Memory Stick” detection
message appears after inserting a “Memory Stick.”
Note
Connect the AC power adaptor when saving data to a “Memory Stick” as this operation
consumes considerable battery power. If the battery power is insufficient, you cannot use
the “Memory Stick.”
1
Insert a “Memory Stick” into the “Memory Stick”
slot of the Remote Commander.
For details, see “Inserting a “Memory Stick”” (page 200).
2
Press the [SAVE] key.
z Tip
If you press the [CLOSE] key, the display
returns to the previous one without saving.
The Remote Commander starts saving the file. When saving of the file is
correctly complete, the confirmation display appears. If you fail to save
the file, an error message appears. For details on the error message, see
page 208.
If another file has already been saved, a confirmation message for
overwriting appears. Press the [YES] key to start saving. If you press the
[NO] key, the display returns to the previous one without saving.
z Tip
If you press the [NO] key, the procedure finishes without saving.
Note
Do not remove the “Memory Stick” or disconnect the AC power adaptor while
saving the file.
3
Press the [OK] key in the confirmation display.
The display returns to the display in step 2.
When the display in step 2 is shown, press the [CLOSE] key to return to
the Home display.