Filter
Top Products
27
Getting Started
Continued
Installing the USB driver
To connect a computer and the Remote Commander using the supplied
USB cable, installing the USB driver to the computer is necessary.
Follow the instructions below to install.
Notes
• If the AC power adaptor is not connected to the Remote Commander, USB cannot be
detected by the computer even if the USB cable is connected. Make sure to connect the
AC power adaptor before installing the USB driver.
Or, the USB communication is disconnected if the Remote Commander is unloaded from
the Battery charging stand. Make sure that the Remote Commander is securely loaded
on the Battery charging stand. Or it is recommended to connect the AC power adaptor
directly to the Remote Commander. If the USB communication is disconnected by
mistake, install the USB driver again from the beginning.
• Do not copy the USB driver in the supplied CD-ROM to the computer.
• On Windows 2000 Professional or Windows XP, logon with the ID authorized as the
computer administrator when installing “NAVITUS Design.”
• On Windows 2000 Professional or Windows XP, installing of the driver is required for
each USB port. Therefore, perform the installation for each USB port to which the
Remote Commander is to be connected.
• Messages other than those of the installation procedure of the USB driver described
below may appear depending on the computer. In this case, perform the installation
following the on-screen instructions.
For Windows XP users
1
Close all software running on Windows.
2
Insert the supplied CD-ROM in the CD-ROM drive of the computer.
After a moment, “InstallShield Wizard” of “NAVITUS Design” appears.
3
Click [Cancel] to close “InstallShield Wizard” of “NAVITUS Design.”
4
Connect a computer and the Remote Commander using the
supplied USB cable.
The “Found New Hardware” message appears in the Notification Area in
the lower right-hand of the display. After a moment, “Found New
Hardware Wizard” appears.