Filter
Top Products
50
Continued
Programming the preset codes of components (PRESET)
Programming a preset code using the list of component
preset codes (SEARCH)
The following steps are continued from step 4 on page 44.
Programming a preset code of a TV component is explained here.
1
Press the [SEARCH] key in
the programming method
selection display.
Instructions for the preparation of the
component to be registered appear in the
display. Set the component to the status
as instructed.
2
Press the [OK] key.
The list of preset codes appears in the
display. Make sure that the first preset
code is selected by the cursor.
3
Press the [v] or [V] key to
select a component preset
code by the cursor, aim the
Remote Commander at the
component to be registered,
and then press the [TEST]
key.
The Remote Commander transmits the
remote control signal. One test key signal
is assigned to a preset code. The name of
test key signal is displayed on the left of
the [TEST] key.
z Tip
Each time you press the [v] or [V] key, the cursor moves one line up or down on
the list. If you press the [v] or [V] key for 2 seconds or longer, the list in the
display scrolls.