Filter
Top Products
61
Basic Operations
Note on when teaching a signal to an Alias key/button
An Alias key/button is set to refer to the setting contents of another key/button
and work the same as the reference key/button.
When you teach an Alias button, a message appears and prompts you to select
either the button you pressed or the reference key/button of the pressed button to
teach a signal to. To teach a signal to the Alias button you pressed, press the
[SELECTED KEY] key. To teach a signal to the reference key/button press the
[REFERENCE KEY] key.
If the reference key is not learnable, a message appears. If you press the [OK] key,
the display returns to step 6 on page 59.
When teaching an ALIAS key, the reference key will be learned.
For details on ALIAS, see “Setting a function key of another component to a
Component display (ALIAS)” (page 100).
7
Press and hold down the
button of the remote
control, whose signal you
want to teach to the key or
button, until a beep sounds.
The learned signal is set to the function
key or button. When learning is
complete, the display returns to step 6.
■ If a beep sounds five times
The Remote Commander did not successfully learn the signal
transmitted from the remote control of the component. Learn the remote
control signal again.
Note
A beep also sounds five times when the button of the remote control is not pressed
within 10 seconds after the instruction is shown in the display.
8
To finish all settings, press the COMMANDER OFF
button for 2 seconds or longer.
The display returns to the Home display. Or press the [EXIT] key
repeatedly until the Home display is shown.
Continued