Filter
Top Products
76
Customizing the Home display (HOME EDIT)
Continued
6
Set the label of the
Component key.
Input letters to the label in the label
setting display by pressing the keyboard
using the supplied Stylus.
For inputting letters to the label, see
“Inputting letters (label setting)” (pages
40 - 41).
Specified settings to the label of the Component key besides the
information described on pages 40 - 41 are as follows.
Letter input: Up to 32 letters can be input.
Starting a new line: Available. Starting a new line is counted as a
letter.
Pictographs: Can be input. A pictograph is counted as 4 letters.
Specified settings to the label of the Direct Access button are as follows.
Letter input: Up to 8 letters can be input.
Starting a new line: Not available.
Pictographs: Can be input. A pictograph is counted as 4 letters.
[SIZE]: Not selectable. The letter size is fixed to [Small].
[ALIGN]: Not selectable. The letter location is fixed to
[Center].
Note
You cannot set the same label name as an existing Component key, regardless of
whether characters are upper or lowercase. If you try to set the same label name, a
message appears.
7
When the label setting is complete, press the [OK]
key.
The skin and label are set and the display returns to step 4.
z Tip
If you press the [CANCEL] key, the label will not be set and the display will return
to step 5.
8
To finish all settings, press the COMMANDER OFF
button for 2 seconds or longer.
The display returns to the Home display. Or press the [EXIT] key
repeatedly until the Home display is shown.