Filter
Top Products
96
Customizing the Component display (COMPONENT EDIT)
Continued
To erase all learned data set to the keys/buttons in a
component
You can erase all learned data by specifying the component on the Remote
Commander. This operation erases all learned data you programmed to the
function keys/buttons for a specific component.
Note
Keys that refer to another key will not function properly if the reference key (for Alias or
macro) is deleted.
1
Perform steps 1 to 3 in “Deleting a function key (DELETE)” (page
92).
2
Press the Component key for 2
seconds or longer.
Press the Component key whose learned
data you want to erase for 2 seconds or the
confirmation display of erasing the remote
control signal appears.
3
Press the [YES] key.
The deletion of learned data begins. While
deleting learned data, a message appears.
When the deletion is complete, the display
returns to step 2.
If you press the [NO] key, the display
returns to step 2 without deleting.
4
To finish all settings, press the COMMANDER OFF button for 2
seconds or longer.
The display returns to the Home display. Or press the [EXIT] key repeatedly
until the Home display is shown.