Filter
Top Products
12
Specifications
SA-VE505/VE502
For the U.S. model
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
with 8 ohm loads both channels driven, from
20 - 150 Hz; rated 100 watts per channel
minimum RMS power, with no more than
0.8% total harmonic distortion from
250 milliwatts to rated output.
SS-MS5 (front, center, and rear
speakers)
Speaker system Full range × 2,
magnetically shielded
Speaker units 5 cm (2 in.), balance drive
type
Enclosure type Bass reflex
Rated impedance 8 ohms
Power handling capacity
Maximum input power: 120 watts
Sensitivity level 87 dB (1 W, 1 m)
Frequency range 120 Hz - 20,000 Hz
Dimensions (w/h/d) Approx. 77 × 131 ×
105 mm (3
1
/8 × 5
1
/4 ×
4
1
/4 in.), including front
grille
Approx. 131 × 125 ×
113 mm (5
1
/4 × 5 ×
4
1
/2 in.), with center
speaker stand attatched
Mass Approx. 730 g (1 lb 10 oz)
each
SA-WMS5 (subwoofer)
System
Speaker system Active subwoofer,
magnetically shielded
Speaker unit Woofer: 20 cm (8 in.),
cone type
Enclosure type Advanced SAW type
Practical maximum output
100 W
Reproduction frequency range
26 Hz - 150 Hz
Inputs
LINE IN (input pin jack)
SPEAKER IN (input terminals)
Outputs
LINE OUT (output pin jack)
SPEAKER OUT (output terminals)
General
Power requirements
USA and Canada: 120 V AC, 60 Hz
Europe: 220 - 230 V AC, 50/60 Hz
Others: 220 - 240 V AC, 50/60 Hz
Power consumptions 80 W
Troubleshooting
Should you encounter a problem with your
speaker system, check the following list and
take the indicated measures. If the problem
persist, consult your nearest Sony dealer.
There is no sound from the speaker
system.
•Make sure all the connections have been
correctly made.
•Make sure the volume on the amplifier
has been turned up properly.
•Make sure the program source selector on
the amplifier is set to the proper source.
•Check if headphones are connected. If
they are, disconnect them.
There is distortion in the subwoofer sound
output.
•Make sure the cut-off frequency on the
subwoofer set to the maximum level
(200 Hz) when Dolby Digital (AC-3) is on
(SA-VE305 only).
•Check if any sound-enhancing functions
have been activated on the amplifier. If
they have, turn them off.
There is hum or noise in the speaker
output.
•Make sure all the connections have been
correctly made.
•Make sure none of the audio components
are positioned too close to the TV set.
The sound has suddenly stopped.
•Make sure all the connections have been
correctly made. Contact between bear
speaker wires at the speaker terminals
may cause a short-circuit.