Filter
Top Products
93
Troubleshooting
Additional Information
Timer recording
The timer does not
operate.
• Check that the clock is set.
• Make sure a tape has been inserted.
• Check that the safety tab has not been removed.
• Make sure the tape is not at its end.
• Make sure a programme has been set for timer recording.
• Make sure your timer settings are past the current time.
• Check that the decoder is turned on.
• Check that the satellite tuner is turned on.
• The clock stops if the VCR is disconnected from the mains
for more than one hour. Reset the clock and timer.
• Turn the power off and unplug the mains lead.
The SHOWVIEW
menu or the TIMER
menu does not appear.
• Check that TIMER OPTIONS in the OPTIONS-2 menu is
set correctly (see page 85).
The VPS/PDC function
does not operate
properly.
• Check that the clock and the date are set correctly.
• Check that the VPS/PDC time you set is the correct one
(there might be a mistake in the TV programme guide). If
the broadcast you wanted to record did not send the good
VPS/PDC information, the VCR will not start recording.
• If the reception is poor, the VPS/PDC signal might be altered
and the VCR might not start recording.
Synchronized Recording
The SYNCHRO REC
button turns off while
recording or does not
go back to recording
standby mode.
• The tape has reached its end. Insert a new tape and press
SYNCHRO REC again.
The Synchronized
Recording function
does not work.
• The connected equipment was not turned off.
Turn off the connected equipment and press SYNCHRO
REC again.
• There was a power failure. Press SYNCHRO REC again.
The programme
recorded with the
Synchronized
Recording function is
incomplete.
• If the settings for timer recordings and Synchronized
Recording overlap, the programme that starts first has
priority and the second programme starts recording only
after the first programme has finished.
• There was a power failure. Press SYNCHRO REC again.
Symptom Remedy
continued