Filter
Top Products
Getting Started
8
Step 2 : Setting up the remote commander (continued)
*
1
Press WIDE to switch the wide picture mode on or off.
*
2
Press WIDE, then press VOL +/– to select the wide picture mode you want.
*
3
Press WIDE. The menu appears on the TV screen. Then, push the joystick to >/./
?// to select the wide picture you want and press the joystick (OK).
Notes
• If the TV uses a different remote control system from the one programmed to work
with the VCR, you cannot control your TV with the remote commander.
• If you enter a new code number, the code number previously entered will be erased.
• When you replace the batteries of the remote commander, the code number
automatically resets to 01 (Sony). Reset the appropriate code number.
Code numbers of controllable TVs
If more than one code number is listed, try entering them one at a time until
you find the one that works with your TV.
To make wide mode settings, see the footnotes below this table for the
applicable code numbers.
Code number
06*
1
, 07*
1
, 08*
1
12, 13
22, 23
25
29
67
36
43*
2
38
Code number
01*
1
, 02
68
52
10*
1
, 11*
1
24
27*
1
, 28*
1
, 50*
1
, 51*
1
66
15, 16, 69*
3
17*
1
, 49
Manufacturer
Sony
Akai
Ferguson
Grundig
Hitachi
Mitsubishi
NEC
Nokia
Panasonic
Manufacturer
Philips
Saba
Samsung
Sanyo
Sharp
TEAC
Telefunken
Thomson
Toshiba