Filter
Top Products
Playback
32
EN
After playing back all or part of the tape, this VCR can rewind the tape
to the beginning and stop playback automatically (One Program Play.)
Using an external switch
Connection
Connect an external switch to the ONE PGM PLAY TRIGGER jack at
the rear of the main unit.
Operation
1 Turn on the power of this VCR.
2 Press the external switch.
The ONE PGM PLAY indicator on the front panel lights.
The tape rewinds to the beginning automatically, then playback
starts. After playback stops, the tape rewinds to the beginning
automatically and stops.
Using the ONE PGM PLAY button on this VCR
Use the ONE PGM PLAY button when you check the operation during
Auto Repeat and One Program Play.
1 Turn on the power of this VCR.
2 Press the ONE PGM PLAY button on the operation
panel.
The ONE PGM PLAY indicator on the front panel lights.
The tape rewinds to the beginning automatically, then playback
starts. After playback stops, the tape rewinds to the beginning
automatically and stops.
The point where the tape stops playback
The VCR plays back the tape from the beginning to the first index (if
there is no index on the tape, to the unrecorded portion; if none, to the
tape end), and stops. Then the tape rewinds to the beginning. (The
point where the tape stops is the same as the turning point of the Auto
Repeat play.)
To release One Program Play
Press p STOP.
External switch
One Program Play
ONE PGM PLAY TRIGGER
jack
Tip
About trigger signals:
In the case of an external
switch, short-circuit between
hot and ground conductor of
the ONE PGM PLAY
TRIGGER jack.
If you connect an external
circuit, short-circuit using a
circuit relay or an open
collector.
Caution
While a tape is running, do
not turn off the power, using
an AC timer. The VCR and a
tape may be damaged. When
turning off the power of the
VCR, make sure to press p
on this VCR first to stop the
tape transport, then turn off
the power.
Note
The VCR cannot locate an
index or unrecorded portion
within 20 seconds from the
beginning of the tape.