Sony KD 27FS170 CRT Television User Manual


 
13
Setting Up
KD-27/32/36FS170
2-670-362-21(1)
Setting Up the TV
After you have finished connecting your TV, use Auto Program to set up your analog and
digital channel lists. During Auto Program, the TV will automatically search for available
channels and program receivable channels.
1 Press the POWER button to turn on the TV.
The Initial Setup screen appears.
2 Press the CH+ button on the remote control or on the TV front panel to start Auto Program,
or press the
CH- button to exit.
Auto Program automatically creates a list of receivable analog channels. When completed,
a screen prompts you to continue searching for digital channels.
Searching for digital channels may take 50 minutes or more to complete. A progress bar is
displayed while the channel list is being created.
3 When Auto Program is finished, the lowest numbered channel is displayed.
To run Auto Program again at a later time
Use the Auto Program feature, using the TV’s menus. For analog channels, see page 22.
For digital channels, see page 31.
To add digital channels
Use the Digital Channels/Add feature, as described on page 31.
To reset the TV to factory settings
1 Turn the TV on.
2 Hold down on the remote control.
3 Press and release the POWER button on the TV front panel. The TV will turn itself off, then
back on.
4 Release .
After starting Auto Program, wait until the process is complete to avoid missing some channels that
are available. To re-program receivable channels, run Auto Program again as described on page 22
(analog channels) and page 31 (digital channels).
The Initial Setup screen appears each time you turn on the TV until you perform Auto Program.