Sony KDL-S40A11E Flat Panel Television User Manual


 
No colour on programmes
Select “Reset” in the “Picture Adjustment” menu to return to the factory
settings (page 22).
No colour or irregular colour
when viewing a signal from the
Y, PB/CB, PR/CR jacks of
3
Check the connection of the Y, PB/CB, PR/CR jacks of 3.
Make sure that the Y, P
B/CB, PR/CR jacks of 3 are firmly seated in their
respective sockets.
Sound
Problem Cause/Remedy
No sound, but good picture
Press 2 +/– or % (Mute).
Check that “TV Speakers” is set to “on” in the “Features” menu (page 27).
Noisy sound
See the “Picture noise” causes/remedies on page 42.
Channels
Problem Cause/Remedy
The desired channel cannot be
selected
Switch between digital and analogue mode and select the desired digital/
analogue channel.
Some channels are blank
Scrambled/Subscription only channel. Subscribe to the Pay Per View
service.
Channel is used only for data (no picture or sound).
Contact the broadcaster for transmission details.
Digital channel is not displayed
Check that the aerial is plugged directly into the TV (not through other
equipment).
Contact a local installer to find out if digital transmissions are provided in
your area.
Upgrade to a higher gain aerial.
General
Problem Cause/Remedy
The TV turns off automatically
(the TV enters standby mode)
The TV turns on automatically
Check if the “Timer” is activated (page 28).
If no signal is received or no operation is performed in the TV mode for 10
minutes, the TV automatically switches to standby mode.
Check if the “Timer” is activated (page 28)
Some input sources cannot be
selected
Select “AV Preset” in the “Set Up” menu and cancel “Skip” of the input
source (page 31).
The remote does not function
Replace the batteries.
Problem Cause/Remedy
Continued
43
GB
Additional Information