Filter
Top Products
106
Other Info Other Info
General
Problem Possible Remedies
How to restore Video settings
to factory settings
s Press RESET on the remote control while in the Video Menu (see page 84).
How to restore Audio settings
to factory settings
s Press RESET on the remote control while in the Audio Menu (see page 86).
Cannot cycle through the other
video equipment connected to
the TV
s Be sure the Video Label option is not set to Skip (see page 96).
Cannot operate Menu s If a menu option appears in gray, this indicates that the menu option is not
available.
Lost password s In the password screen (see page 92), enter the following master password: 4357.
The master password clears your previous password; it cannot be used to
temporarily unblock channels.
LED on the TV is lit s The STANDBY LED (see page 16) lights up when the TV is in standby mode. If
the LED blinks continuously, this may indicate the TV needs a service.
s The TIMER LED (see page 16) indicates that the timer is set. When the timer is
set, this LED will remain lit even when the TV is turned off.