Filter
Top Products
— 21 —
**WARNING: Do NOT turn off the power or AC immediately after pressing then . Wait at least 10 seconds.
KV-32S40/32S45/34SL40/34SL40C/34SL40T/34SL45/35S40/35S45/37SL45/
32V40/32V65/34VL65/34VL65C/35V65/37VL65/37VL65C
/
/
PIN AMP (PAMP)
PIN PHASE (PPHA)
V ANGLE (VANG), V BOW (VBOW), UPPER PIN (UPIN)
AND LOW PIN (LPIN) ADJUSTMENTS
1. Input a cross hatch signal.
2. Set to Service adjustment Mode.
3. Select VVANG, VBOW, UPIN, and LPIN with
and .
4. Adjust with
and for the best picture.
5. Write the memory by Pressing
then ** .
V ANGLE (VANG)
V BOW (VBOW)
UPPER PIN (UPIN)
LOW PIN (LPIN)
P BOARD ADJUSTMENTS
PIP V. POSITION (PIPV), PIP H. POSITION (PIPH)
1. Input a color bar signal.
2. Set to service adjustment mode.
3. Select PHOP with and .
4. Adjust with
and for the best balanced position at four
corner P in P display position.
5. Adjust P in P put at lower right position.
6. Write the memory by Pressing then **.
V. SIZE ADJUSTMENT ( VSIZ)
1. Input a cross-hatch signal.
2. Set to Service adjustment mode.
3. Select VSIZ with
and .
4.Adjust with
and for the best vertical size.
5.Write into the memory by pressing
then **.
V. SIZE
V. POSITION ADJUSTMENT (VPOS)
1.Input a cross-hatch signal.
2.Set to Service adjustment Mode.
3.Select VPOS with
and .
4.Adjust with
and for the best vertical center.
5.Write into the memory by pressing
then **.
V. POSITION
H. POSITION ADJUSTMENT (HPOS)
1. Input a cross-hatch signal.
2. Set the Service adjustment Mode.
3. Select HPOS with
and .
4. Adjust with
and for the best horizontal center.
5. Write into the memory by pressing
then **.
H. POSITION
V LINEARITY (VLIN), V CORRECTION (VSCO), PIN AMP
(PAMP) AND PIN PHASE (PPHA) ADJUSTMENTS
1. Input a cross-hatch signal.
2. Set to Service adjustment Mode.
3. Select VLIN, VSCO, PAMP, and PPHA with and .
4. Adjust with
and for the best picture.
5. Write the memory by Pressing
then ** .
V LINEARITY(VLIN)
VS CORRECTION (VSCO)