Filter
Top Products
10
Specifications
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
with 6 ohm loads both channels driven, from
20 - 150 Hz; rated 50 watts per channel
minimum RMS power, with no more than
0.8% total harmonic distortion from
250 milliwatts to rated output.
SS-V230 Front and rear speakers
Speaker system Full range, magnetically
shielded
Speaker units 5 × 9 cm (2 × 3
5
/8 in.),
cone type
Enclosure type Bass reflex
Rated impedance 8 ohms
Power handling capacity
Maximum input power: 100 watts
Sensitivity level 86 dB (1 W, 1 m)
Frequency range 90 Hz - 20,000 Hz
Dimensions (w/h/d) Approx. 70 × 151 ×
126 mm (2
7
/8 × 6 × 5 in.),
including front grille
Mass Approx. 550 g (1 lb 3 oz)
each
SS-CN230 Center speaker
Speaker system Full range × 2,
magnetically shielded
Speaker units 5 × 9 cm (2 × 3
5
/8 in.),
cone type
Enclosure type Bass reflex
Rated impedance 8 ohms
Power handling capacity
Maximum input power: 120 watts
Sensitivity level 88 dB (1 W, 1 m)
Frequency range 90 Hz - 20,000 Hz
Dimensions (w/h/d) Approx. 301 × 70 ×
126 mm (11
7
/8 × 2
7
/8 ×
5 in.), including front
grille
Mass Approx. 1.1 kg (2 lb 7 oz)
SA-WMS230 Subwoofer
System
Speaker system Active subwoofer,
magnetically shielded
Speaker unit Woofer: 16 cm (6
3
/8 in.),
cone type
Enclosure type Advanced SAW type
Continuous RMS power output
(8 ohms, 20 - 150 Hz, 0.8 % THD)
50 W
Reproduction frequency range
28 Hz - 200 Hz
High frequency cut-off frequency
200 Hz
Input
LINE IN (input pin jack)
General
Power requirements 120 V AC, 60 Hz
Power consumptions 45 W
Dimensions (w/h/d) Approx. 205 × 385 ×
385 mm (8
1
/8 × 15
1
/4 ×
15
1
/4 in.), including
front grille
Mass Approx. 10.5 kg
(23 lb 2 oz)
Supplied accessories
Foot pads (20)
Audio connecting cords (2 phono to 2 phono) (3)
Monaural connecting cord (1 phono to 1 phono)
(1)
Speaker connecting cords, 10 m
(32 ft 9
3
/
4
in.) (2)
Speaker connecting cords, 2.5 m
(8 ft 2
1
/
2
in.) (3)
Design and specifications are subject to change
without notice.