![](http://pdfasset.owneriq.net/5/96/59619320-0a28-4096-95d7-d7a30676e430/59619320-0a28-4096-95d7-d7a30676e430-bg14.png)
20 (GB)
Watching the Picture
Before you start
• Turn on the monitor.
• Turn on the connected equipment and play a video
source.
• To display the input signal information on the screen
when turning on the power or switching the input
signal, set “DISPLAY” in the CONFIG menu to ON.
• To select the on-screen language used in the menu,
see page 31 (GB).
Switching the Input Signal
1 Press CTRL on the control panel of the monitor.
The RGB1, YUV, RGB2, LINE, and Y/C buttons
light up.
2 Select the input source to be displayed by pressing
the following buttons.
RGB1:Selects the audio and video signal input
from the RGB1 connectors when the input
signal is an RGB signal.
YUV: Selects the audio and video signal input
from the RGB1 connectors when the input
signal is a component signal.
RGB2:Selects the audio and video signal input
from the RGB2 connectors.
LINE: Selects the audio and video signal input
from the VIDEO IN connector and
AUDIO IN jack among the LINE
connectors.
Y/C: Selects the audio and video signal input
from the Y/C IN connector and AUDIO
IN jack among the LINE connectors.
PAL
LINE Y/C
The selected input signal appears on the monitor
screen.
You can also switch the input signal with the
Remote Commander.
Watching the Picture
Note
We recommend input source video equipment
equipped with a TBC (time base corrector). If the
monitor receive a signal without TBC, the picture may
disappear due to disturbance of the sync signal.
Switching the Display Mode
Displaying Closed Captions
1 Press MENU.
The main menu appears on the monitor screen.
ENTER
MENU
MA IN MENU
PIC CONTROL
PIC SIZE
CONF IG
MEMORY
REMOTE
STATUS
SELECT SET END
2 Press M/m to move the cursor (B) to “CONFIG”
and press ENT.
The CONFIG menu appears on the monitor
screen.
ENTER
MENU
CONF IG
DISPLAY : ON
CLOSED CAPTION: OFF
COLOR SYSTEM : AUTO
SCREEN F ILL :CENTER
POWER CONTROL
SCREEN SAVER
TIME SET
LANGUAGE
SELECT SET END
3 Press M/m to move the cursor (B) to “CLOSED
CAPTION” and press ENT.
The following menu appears on the monitor
screen.
CLOSED CAPTION: OFF
Color system or horizontal/vertical frequency
Signal type