Filter
Top Products
16 (US)
Step 6: Install the display on the Plate Unit
WARNING
Do not connect the power cord to a wall outlet before the installation is completed. If the power cord is
pinched, a short circuit may occur, causing an electric shock.
Be careful not to stumble over the cables or the display.
1
Align the holes on the Mounting
Hook Units with the corresponding
holes on the rear of the display.
Secure them to the display using
four screws.
For the KLV-26HG2, use the screws supplied (+PSW5
× L16). For the KDL32XBR950 and the KLV30XBR900,
use the screws you removed in Step 5.
Notes
• Lay the display face down on a soft cloth.
•When using an electric screwdriver to tighten the
screws, the torque must be approx. 2 N•m.
KLV-26HG2
KDL32XBR950/KLV30XBR900
The supplied screws
(+PSW5 × L16)
Mounting Hook Units
Soft cloth
Rear of the display
The screws removed
in Step 5
Mounting Hook Units
Soft cloth
Rear of the display