Filter
Top Products
Advanced Operation 19
Manual Programme Preset menu
The ‘Manual Programme Preset’ option in the ‘Manual Set Up’ menu allows you to manually tune
channels.
With the ‘Manual Programme Preset’ option highlighted, press b to enter the ‘Manual Programme
Preset’ menu. Press v or V to highlight the channel you wish to tune. Press b twice to select the
SYS column. Press v or V to select the TV broadcast system (B/G for western European countries,
D/K for eastern European countries or EXT for an external input source). Press b to confirm and
select the CH column. Press v or V to select the channel tuning (C for terrestrial channels, S for
cable channels or F for direct frequency input). Press b to confirm. You now need to tune the
channel by one of the following methods:
(a) If you know the channel number of the TV broadcast, the VCR test signal or the
frequency:
Press the numbered buttons on the remote control to enter the channel number. Press OK to
store.
(b) If you do not know the channel number:
Press v to select SEARCH. The TV set automatically searches for the next available TV
broadcast channel or the VCR test signal. When a channel has been found press either OK to
store or v to continue searching.
(c) For external input sources (EXT):
Press v to select AV1, AV2, AV3, AV4 or AV5 depending on which socket you have connected
your equipment to. Press OK to store.
Labelling a channel
Names for channels are usually taken automatically from Teletext (if available). This name will be
displayed briefly on screen when the channel is selected. The ‘LABEL’ option in the ‘Manual
Programme Preset’ menu allows you to assign a name of your choice up to 5 characters or
numbers.
With the ‘Manual Programme Preset’ option highlighted, press b to enter the ‘Manual Programme
Preset’ menu. Press v or V to highlight the channel number you require. Press b repeatedly to
select the LABEL column. Press v or V to select the first character. Press b to confirm this
character. Select the other characters in the same way. After selecting all required characters, press
OK to store.
Skipping a channel
The ‘SKIP’ option in the ‘Manual Programme Preset’ menu allows you to skip unused channel
positions when selecting channels with the PROG+/- buttons. However, you can still select skipped
channels by using the numbered buttons on the remote control.
With the ‘Manual Programme Preset’ option highlighted, press b to enter the ‘Manual Programme
Preset’ menu. Press v or V to highlight the channel number you require. Press b to select the SKIP
column. Press v to select On (select Off to remove the SKIP feature). Press OK to store.
1
23
4
5
6
7
8
9
0
MODE
36FS76 B5 Part 5 GB.fm Page 19 Tuesday, May 7, 2002 4:43 PM