Filter
Top Products
42
Additional Information
Troubleshooting (continued)
Possible cause
Symptom
Solutions
• Check the power cord, antenna and
the VCR connections.
• Press
?/1
(power).
• Press ! (main power) on the TV to
turn off the TV for about five
seconds, then turn it on again.
• Press ¸ + to increase the volume
level.
• Press % to cancel the muting.
• Press A/B until a better sound is
heard.
• Do not use a hair dryer or other
equipment near the TV.
• Adjust the antenna direction for
minimum interference. Contact a
Sony dealer for advice.
• Use a highly directional antenna.
• Use the fine tuning (“FINE”) function.
• Adjust the antenna direction. Contact
a Sony dealer for advice.
• Turn off or disconnect the booster if it
is in use.
•
Display the “PICTURE” menu and select
“ADJUST” of “PICTURE MODE”, then
adjust the “COLOR” level.
• Display the “SETUP” menu and check
the color system (“COLOR SYS”) setting
(usually set this to “AUTO”).
• Adjust the antenna direction. Contact
a Sony dealer for advice.
Page
4
11
12
12
12
21
–
–
–
39
–
–
31
35
–
• The power cord,
antenna or VCR is
not connected.
• The TV is not turned
on.
• The volume level is
too low.
• The sound is muted.
• The broadcast signal
has a transmission
problem.
• There is local
interference from
cars, neon signs, hair
dryers, power
generators, etc.
•
Broadcast signals are
reflected by nearby
mountains or buildings.
• The antenna direction
needs adjustment.
• Use of a booster is
inappropriate.
• The color level
setting is too low.
•
The color system setting
is inappropriate.
• The antenna direction
needs adjustment.
No picture
No sound
Good picture
No sound
Dotted lines or
stripes
Double images or
“ghosts”
No color