Filter
Top Products
8
Presetting Channels
Automatic and manual programming are available.
Automatic programming presets receivable channels
automatically from the lowest frequency to the highest.
With manual programming, the active channels can be
preset in any desired sequence.
Automatic Programming
While pressing the MEMORY button, press the 1 button.
All receivable channels will be tuned in and memorized
automatically from the lowest-frequency channel to the
highest. When no more channels can be found, the
programming mode will be automatically released and the
lowest channel number will appear on the program
indicator.
Notes
• The channels previously preset will not remain in the
tuner’s memory.
• Do not press the MEMORY ADD/ERASE buttons or turn
the tuner off while automatic programming. The channel
scan memory may be erased.
Manual Programming
To add desired channels
1 Press the 0-9 buttons and ENTER to select the channel
you want to add in the channel scan memory.
For example, to select channel 25, press 2, 5 and ENTER.
2 While pressing the MEMORY button, press the ADD
button.
“Add ” appears on the program indicator and the
channel is added in the channel scan memory.
To add other channels, repeat steps 1 and 2.
To erase unnecessary channels
1 Press the CHANNEL +/– buttons to select the channel
you want to erase.
2 While pressing the MEMORY button, press the ERASE
button.
“– – –” appears on the program indicator and the
channel is erased from the channel scan memory. The
next time you press the CHANNEL +/– buttons, the
channel you erased will be skipped.
To erase other channels, repeat steps 1 and 2.
To clear the channel settings
While pressing the MEMORY button, press the 3 button.
The tuner will restore the factory settings.
Fine Tuning
When the image of the selected channel is unclear:
1 Press the CHANNEL +/– button to select the channel
you want to fine-tune.
2 Press the FINE button for a few seconds until the AFT
indicator flashes.
3 Press the CHANNEL + or the CHANNEL – button to
get the best image and sound quality.
4 Press the FINE button.
If you manually fine-tune a channel, the AFT circuit will not
function and the AFT indicator will not light up on the
channel.
Notes
• If you do not press the CHANNEL +/– button within a
few seconds after step 2, the tuner will return to its status
in step 1.
• To reset a manually tuned channel to automatic fine
tuning, following “Manual Programming” on this page,
erase the channel once and add the channel again.