SunBriteTV Model 4717HD and 5517HD Operator’s Manual
Page 11
TV Installation – Rear Panel Connections
Switching Sources for Ports:
Your SunBrite TV oers several options when connecting
your devices to the TV. The chart below will help you
understand which source you switch to for each of the
ports.
CONNECTING TO AN ANTENNA
1. Make sure the power to the TV is turned o.
2. Connect the Coaxial RF cable from your
antenna or digital cable to the ATSC/NTSC port o
the back of the TV.
3. Turn on the TV.
4. Select TV (Air) for antenna or TV (Cable) for
digital cable from either your remote control’s
source button or source button on the right side
of the TV.
5. Use the On-Screen Display to scan for channels.
Connecting to Digital Cable without Cable Box or Antenna
Connecting to Cable or Antenna
1. Make sure the power of the TV is turned o.
2. Connect the Coaxial RF cable from your
antenna or cable to the
ATSC/NTSC port o the back of the TV.
3. Turn on the TV.
4. Select TV (Air) for antenna or TV (Cable) for
cable from either your remote control’s source
button or source button on the right side of the
TV.
5. Use the On Screen Display to scan for channels.
Please Note :
1. Not all broadcasts are in High Denition (HD). Please refer to your local broadcasting stations for more information.
2. The TV’s tuner is designed for HDTV therefore requires a stronger signal than normal TVs. If you cannot achieve that
signal level with your antenna or cable, the TV might lose picture or sound.