SunBriteTV SB-6560HD Flat Panel Television User Manual


 
Page 32
Care of SunBriteTV
Caring for the LCD Panel
1. Cleaning the LCD Panel:
With your TV turned o , gently wipe the surface of the display panel with a damp (with water) micro ber, cotton or  annel
cloth. (Do not use tissues, rags, sponges or paper towels because they may damage the screen and leave lint pieces behind).
If the LCD panel is very dirty, you can mix equal parts of isopropyl alcohol and distilled water in a clean spray bottle, spray the
mixture onto the cloth (do not spray the solution directly on the panel) and gently clean the panel.
A “special outdoor formula” LCD Cleaning Kit is now available and can be ordered from SunBriteTV.
2. When the TV is not in use, keep it covered with the SunBriteTV Outdoor Dust Cover
The  tted dust cover is constructed with weatherproof 4-ply polypropylene UV protection fabric that protects the window
from direct and indirect sunlight, and keeps wind-blown objects from scratching the surface of the window.
To order a SunBriteTV LCD Cleaning Kit or Replacement Outdoor Dust Cover, contact your Authorized SunBriteTV dealer,
SunBriteTV’s Customer Care Center at 800.331.4626, or visit www.sunbritetv.com.
General TV Cleaning
Remove any dirt and salt deposits from the unit, being careful to rinse the cloth frequently to avoid scratching the TV or screen
surface. Avoid using harsh chemicals, abrasives, or solvents when cleaning any surface on the unit.
Snow and Ice
Use a soft brush and towel to remove snow and ice from the unit.
Fiber Filter
Over time, the  ber  lter collects dirt and must be cleaned or replaced.
The Fiber Filter is located on the back of the unit, inside the Intake Vent at the top of the TV (Figure 1).
1. Release the Fiber Filter by pulling it out from the corner of the Intake Vent (Figure 2). Notice how the Fiber Filter  ts in the upper
and lower channels, and tightly against the side.
2. Pull the Fiber  lter out of the TV, and wash it with mild detergent and warm water. After rinsing, let the Fiber Filter dry completely.
3. Put the Fiber Filter back up into the Intake Vent pushing the  lter  rst into the upper channel, then  t it into the lower channel.
Make sure  lter  ts tightly against the side. (Figure 3).
CAUTION! NEVER SPRAY OR DIRECT A HOSE INTO THE VENT AREA OF THE TV.
To Order Replacement Filters, contact SunBriteTV’s Customer Care Center at 800.331.4626.
Figure 1
Figure 3
Fiber Filter
Intake Vent
Fiber
Filter
Figure 2